The Input section allows setup of various controllers recognized by Meedio.
The first sub-tab Commands allows for customizing the keys or buttons used for a specific function in Meedio.
The commands setup tab.
How to program a new button or keypress
Select the action that will be changed (for example
"ChannelUp")
and click the 
button found on the right side, it will stick
inwards.
You can then press the intended key or button on the input device.
The 
check box advances to the
next command in the list after the previous command has been learned.
When all actions wished to be changed have been
completed, click the button again to have the button raise
and turn off the learning mode.
Pressing 
will clear any mapped
keys or buttons of the selected command.
allows a specific input device's
mappings to be deleted while keeping the other device mappings intact.
Simply select the device in the drop down list, and then click the "Clear
all for" button.
How to add a Jump Target
Click the 
button, a new box will
pop-up asking to provide a name for the new command.
Map a button or key to the new command by following the instructions outlined above in the How to program a new button or keypress section.
Once this is done click the 
and
select the target. For more on assigning a jump target name to a module
see the Customizing the Main Menu
section.
|
|
|
The Input plug-ins sub-tab is where Meedio plugins for remotes or other similar control devices are enabled or disabled and configured.
The input plugins tab.
|
|
|
and giving a name to your current setup.
and select the profile you wish to restore.